2008 Jeep Commander Blend Door Actuator

2008 Jeep Commander Blend Door Actuator

Jeep Commander On the 2008 Jeep Commander, when the air temperature is only correct on one side of the dash, this is most commonly due to a faulty Blend Door Actuator. This is a little motor that turns the door internal of the HVAC housing. It is used to switch between heat and A/C as commanded by the control panel. You can find the passenger’s side actuator is located behind the passenger’s side dash mounted to the side of teh HVAC housing. To gain access, the glove compartment will need…

Read More

2010 Jeep Liberty C1008 Brake Fluid Level

2010 Jeep Liberty C1008 Brake Fluid Level

Jeep Liberty On the 2010 Jeep Liberty,  the C1008 is a fairly straight forward code pointing to a problem with the Brake Fluid Level Sensor. You will find the Level Sensor mounted to the side of the brake fluid reservoir. Inspect the electrical connector and harness for any loose, broken or damaged wires. If the visual inspection checks ok, replacing the Brake Fluid Level Sensor should solve the problem.To remove the sensor, squeeze the tabs together while pulling on the sensor. Does your vehicle have a similar problem? Get connected to a Live Q&A…

Read More

2009 Jeep Grand Cherokee Actuator

2009 Jeep Grand Cherokee Actuator

Jeep Grand Cherokee On the 2009 Jeep Grand Cherokee, when the A/C is working correctly on one side but not the other, this means the system is working correctly, but the air is not being switched correctly. This is most commonly due to a faulty Blend Door Actuator Motor. This motor is what “turns the door” inside the HVAC housing according to the selection on the control panel. You can find the actuator located behind the glove box, mounted to the HVAC housing. Carefully inspect the electrical connector for any…

Read More