2004 Hyundai SantaFe 2.7L P0335 P1372

2004 Hyundai SantaFe 2.7L P0335 P1372

Hyundai SantaFe On the 2004 Hyundai SantaFe with the 2.7L engine, the P0335 and P1372 codes are related. Both point to a problem with the Crankshaft Position Sensor. This sensor plays a role in spark delivery, so if/when faulty, can cause the symptoms you have described above. The sensor is located just below the ignition coil pack. Carefully inspect the electrical connector and wire harness for any loose, broken or damaged wires. If no problems are found, the Crankshaft Position Sensor will need to be replaced. To replace, unplug the electrical connector. Remove…

Read More

2003 Hyundai Santa Fe 3.5L P0441

2003 Hyundai Santa Fe 3.5L P0441

Hyundai Santa Fe On the 2003 Hyundai Santa Fe with the 3.5L engine, the P0441 points to a problem with the EVAP Purge Control System. There are a couple of things to check here. First, Check the underside of the fuel cap for any cracks or signs of defects that may keep the cap from sealing correctly. If there are any doubts about the inspection of the cap, replace it. Keep in mind, you will need a cap that meets OE Specs. Those “universal” or “locking” fuel caps sold at…

Read More

2008 Hyundai Santa Fe P0441 Incorrect Purge

2008 Hyundai Santa Fe P0441 Incorrect Purge

Hyundai Santa Fe On the 2008 Hyundai Santa Fe, the P0441 is a fairly straight forward code pointing to a problem with the Purge Control Solenoid Valve (PCSV). These are actually very common fail items on these vehicles. The PCSV is located on the driver’s side of the engine, just below the throttle body. For best access, remove the air intake duct from the throttle body. Carefully inspect the rubber lines for any cracks, holes or disconnections. Inspect the electrical connector and wire harness for any loose, broken or damaged wires. If…

Read More

2013 Hyundai Sonata Tire Pressure

2013 Hyundai Sonata Tire Pressure

Hyundai Sonata On the 2013 Hyundai Sonata, the recommended tire pressure for this vehicle is 33psi. If you find that there is a tire which is under-inflated, fill the tire and then drive the vehicle. The light should reset itself in under 10 minutes. If the light does not go off and you are sure all tires are at correct pressure, then there is a problem in the tire monitoring system somewhere. Very commonly, this is a faulty tire pressure sensor. The pressure sensor is mounted inside the tire as part…

Read More

2002 Hyundai Accent P1401 DM-TL

2002 Hyundai Accent P1401 DM-TL

Hyundai Accent On the 2002 Hyundai Accent the P1401 is actually a known problem, and Hyundai has issued a Technical Service Bulletin that states the common cause for this issue is “Water leakage into the DM-TL (Diagnosis Module-Tank Leakage) may result in corrosion of the DMTL connector pins. To correct this condition, replace the DM-TL and DM-TL wiring connector.”. It’s located under the vehicle, on the rear, driver’s side. Does your vehicle have a similar problem? Get connected to a Live Q&A session with a certified Auto Mechanic and get your…

Read More

Chip Install: 2009 Hyundai Accent 1.6L

Chip Install: 2009 Hyundai Accent 1.6L

On the 2009 Hyundai Accent, the IAT is built into the Manifold Absolute Pressure (MAP) Sensor. The MAP/IAT Sensor is located on the top of the intake plenum, to the left of the Throttle Position Sensor and Throttle Body Assembly. At the MAP/IAT Sensor, the IAT wires are: Wire #3 = IAT Signal ( + ) Wire #4 = Ground ( – ). Does your vehicle have a similar problem? Get connected to a Live Q&A session with a certified Auto Mechanic and get your answers on this problem now!

Read More

2002 Hyundai Santa Fe Window Motor

2002 Hyundai Santa Fe Window Motor

Hyundai Santa Fe On the 2002 Hyundai Santa Fe, when the window is “off track” on this vehicle, due to the nature of the setup on how the window is raised and lowered, there usually is no off track adjustment that can be made. The window “track” is kept in line with the use of a Window Regulator. So, when the glass appears to be “off track” this is most commonly due to a faulty Regulator or a problem with the glass-to-regulator connection. The window regualtor is a x-type, scissor…

Read More

2005 Hyundai Elantra P0030 Oxygen Sensor

2005 Hyundai Elantra P0030 Oxygen Sensor

Hyundai Elantra On the 2005 Hyundai Elantra, the P0030 is a fairly straight forward code pointing to a fault with the internal heater for the Oxygen Sensor for Bank 1 / Sensor 1. The on-board computer uses this internal heater to get the sensor to normal operating temps within a matter of seconds on cold starts. When it attempts to activate the heater and there is no repsonse, the P0030 is set. Carefully inspect the electrical connector and wire harness looking for any loose, broken or damaged wires. If the…

Read More

2009 Hyundai Accent IAT/MAP Sensor

2009 Hyundai Accent IAT/MAP Sensor

Hyundai Accent On the 2009 Hyundai Accent, when adding a Performance Chip, it is most commonly installed to the Intake Air Temp (IAT) Sensor. On this vehicle, the IAT is built into the Manifold Absolute Pressure (MAP) Sensor. At the MAP/IAT Sensor, Wire #3 is the IAT Signal ( + ) and wire #4 is Ground ( – ). Does your vehicle have a similar problem? Get connected to a Live Q&A session with a certified Auto Mechanic and get your answers on this problem now!

Read More