Chip Install: 2013 Chrysler 300 3.6L

Chip Install: 2013 Chrysler 300 3.6L

On the 2013 Chrysler 300 3.6L, The IAT is a stand-alone, 2-wire sensor. The IAT Sensor is mounted to the Air Duct, near the filter housing. At the IAT Sensor, the wire colors are:   Dark Blue/Light Green = IAT Signal ( + ) Brown = Ground ( – ) Does your vehicle have a similar problem? Get connected to a Live Q&A session with a certified Auto Mechanic and get your answers on this problem now!

Read More

2003 Chrysler PT Cruiser P0522 Oil Pressure

2003 Chrysler PT Cruiser P0522 Oil Pressure

Chrysler PT Cruiser On the 2003 Chrysler PT Cruiser, the P0522 is a fairly straight forward code pointing to a fault with the Oil Pressure Sensor (aka Oil Pressure Switch). This is a actually a fairly common problem item on these vehicles. Carefully inspect the electrical connector and as far up the harness as you can, looking for any loose, broken, damaged or oil-soaked wires. If the visual inspection checks ok, replacing the Oil Pressure Sensor is the most common solution here. Does your vehicle have a similar problem? Get…

Read More

2007 Chrysler 300C Low Oil Pressure

2007 Chrysler 300C Low Oil Pressure

Chrysler 300C On the 2007 Chrysler 300C, when the Oil Pressure drops at idle but rises when under acceleration, yet there are no unusual engine noises like ticking or knocking, this is most common due to a faulty Oil Pressure Sensor. Over time, when the sensor wears out, it tends to lose the ability to read the correct oil pressure at lower RPM’s and/or when the oil is hot. You can find the Oil Pressure Sensor located behind the Alternator. Carefully inspect the electrical connector for any loose or oil-soaked wires. If…

Read More

2008 Chrysler Aspen Fuel Filter Service

2008 Chrysler Aspen Fuel Filter Service

Chrysler Aspen On the 2008 Chrysler Aspen, there is no external, stand-alone Fuel Filter. The Fuel Filter is built into and part of the Fuel Pump Assembly. There is a filter built into the Pump Assembly Housing and an “inlet” (aka “sock”) filter at the base of the pump assembly. The Fuel Pump Assembly is located inside the fuel tank. Does your vehicle have a similar problem? Get connected to a Live Q&A session with a certified Auto Mechanic and get your answers on this problem now!

Read More

2001 Chrysler Sebring Clockspring

2001 Chrysler Sebring Clockspring

Chrysler Sebring On the 2001 Chrysler Sebring, when the Air Bag light is on and the Horn doesn’t work (and in most cases, the Cruise isn’t working either, if equipped) these are all related. These items are all connected by the Clockspring Assembly. This Clockspring is what keeps the wires to these items from “getting tangled” when the steering wheel is turned. This is actually a fairly common Chrysler problem. The Clockspring is located at the top of the steering column. To access, the Steering Wheel will need to be…

Read More