2002 Hyundai Accent P1401 DM-TL

2002 Hyundai Accent

Hyundai Accent On the 2002 Hyundai Accent the P1401 is actually a known problem, and Hyundai has issued a Technical Service Bulletin that states the common cause for this issue is “Water leakage into the DM-TL (Diagnosis Module-Tank Leakage) may result in corrosion of the DMTL connector pins. To correct this condition, replace the DM-TL and DM-TL wiring connector.”. It’s located under the vehicle, on the rear, driver’s side. Does your vehicle have a similar problem? Get connected to a Live Q&A session with a certified Auto Mechanic and get your…

Read More

Chip Install: 2009 Hyundai Accent 1.6L

2009 Hyundai Accent

On the 2009 Hyundai Accent, the IAT is built into the Manifold Absolute Pressure (MAP) Sensor. The MAP/IAT Sensor is located on the top of the intake plenum, to the left of the Throttle Position Sensor and Throttle Body Assembly. At the MAP/IAT Sensor, the IAT wires are: Wire #3 = IAT Signal ( + ) Wire #4 = Ground ( – ). Does your vehicle have a similar problem? Get connected to a Live Q&A session with a certified Auto Mechanic and get your answers on this problem now!

Read More

2009 Hyundai Accent IAT/MAP Sensor

2009 Hyundai Accent

Hyundai Accent On the 2009 Hyundai Accent, when adding a Performance Chip, it is most commonly installed to the Intake Air Temp (IAT) Sensor. On this vehicle, the IAT is built into the Manifold Absolute Pressure (MAP) Sensor. At the MAP/IAT Sensor, Wire #3 is the IAT Signal ( + ) and wire #4 is Ground ( – ). Does your vehicle have a similar problem? Get connected to a Live Q&A session with a certified Auto Mechanic and get your answers on this problem now!

Read More