2009 Chevy Cobalt TPMS Relearn Procedure

2009 Chevy Cobalt

Chevy Cobalt




On the 2000 Chevy Cobalt, after replacing a Tire Pressure Sensor, the TPM system will need to go through a relearn procedure. The preferred method to complete the procedure is with the use of a scan-tool that can interact with the TPMS system. If you do not have access to such a scan-tool, an alternate procedure can be done. Here is the procedure:

  1. Ignition ON, initiate the TPM Learn Mode using one of the following procedures:

    • On vehicles equipped with keyless entry, simultaneously press the keyless entry transmitters lock and unlock buttons until a double horn chirp sounds indicating the Learn Mode has been enabled. The left front turn signal will also be illuminated.

    • On vehicles not equipped with keyless entry, press and release the driver information center (DIC) INFO button until the TIRE LEARN message appears on the DIC display. Press and hold the SET/RESET button until a double horn chirp sounds indicating the Learn Mode has been enabled. The left front turn signal will also be illuminated.

  1. Starting with the left front tire, learn the tire pressure using one of the following methods:

    • Hold the antenna of the J-46079 aimed upward against the tire sidewall close to the wheel rim at the valve stem location. Press and release the activate button and wait for a horn chirp. Once the horn chirp has sounded, the sensor information is learned and the turn signal in the next location to be learned will illuminate.

  • Increase/decrease the tire pressure for 8-10 seconds then wait for a horn chirp. The horn chirp may occur before or up to 30 seconds after the 8-10 second pressure increase/decrease time period has been reached. Once the horn chirp has sounded, the sensor information is learned and the turn signal in the next location to be learned will illuminate.

  1. After the horn chirp has sounded and the right front turn signal is illuminated, repeat step 2 for the remaining 3 sensors in the following order:

  1. Right front

  2. Right rear

  3. Left rear

  4. When the left rear sensor has been learned and a double horn chirp has sounded, the learn process is complete and the RCDLR exits the learn mode.

  5. Ignition OFF, adjust all tires to the recommended pressures.

 

Does your vehicle have a similar problem? Get connected to a Live Q&A session with a certified Auto Mechanic and get your answers on this problem now!


post-divide


post-divide



0.00 avg. rating (0% score) - 0 votes

Related posts