On the 2005 Ford F-150 with the 5.4L engine, P2195 and P2196 are stating that both banks are running “lean”. There are a few different things that can cause this issue. First- check the Fuel Filter. Remove the filter and try to blow through it. Any resistance and the Fuel Filter will need to be replaced. If the fuel filter is ok, a fuel pressure reading should be taken to ensure the fuel pump is working at normal capacity. Correct fuel pressure for this vehicle is: Key-On/Engine-Off: 35-45 psi / Key-On/Engine-Running: 28-45 psi. If pressure is out of specs, replace the fuel pump. If these check ok, next move onto the air filter housing, duct and filter element. Inspect the duct for any cracks, holes or loose connections. Make sure the filter box is sealed tightly and correctly. Inspect the filter element and make sure it is not excessively dirty, restricting air flow. With the engine running, listen for any “sucking” or “hissing” noises. Inspect as many vacuum lines on the top and rear of the engine as you can see, looking for any cracks, holes or loose/missing connections. Make sure there are no leaks in the exhaust system. If these check ok, an intake air leak should be done to make sure there are no leaks. With the engine running, carefully and sparingly spray some throttle cleaner around the base of the intake. If the engine responds, this is a sign of a leak and the intake gasket will need to be replaced (make sure to visual inspect the manifold itself for any cracks and the PCV valve tube at this time as well). If these all check ok, then the problem will lie in the Mass Air Flow Sensor. Inspect the electrical connector for any loose, broken or damaged wires. If the visual inspection checks ok, then there IS a “cleaner” for the MAF sensor, however, in experience, it’s usually not a 100% fix, and when it does work, it’s usually not for long, and MAF replacement is usually necessary.
Does your vehicle have a similar problem? Get connected to a Live Q&A session with a certified Auto Mechanic and get your answers on this problem now!
If this article was helpful, leave a rating: